i went back and revised that list of mods and i think i got just about everything i think id want...i really didnt put that much time obviously on the list of mods i gave vaughn a couple months ago.
Most complete copy of mods
Pads: 36+2
•All of the “Dukes Mods” (sorry if I repeat them)
•Fully squared up thigh (top and inside squared—no taper at all please)
•no thighboard
•HD-80 inserts inside the shin knee boot and thigh (Dukes Mods)
•Extended and Squared up knee wing (7” long by 6”)
•triangular wedge between boot and leg outer side rolls to keep pads straighter in butterfly
•HD 80 foam in the outer side rolls to make them stiffer
•full clarino boot area for better durability
•full nash leg channel (inside of knee lock and full calf wrap featured below, and the leg channel itself) but does not continue into boot area
•No stabilizing stripes
•All leather straps
•Internal Strapping (not stitched)
•No piping on the inside of the pad (by the calf stabilizer) medial roll?
•rounded toe box
•Extended knee stacks same size as square knee wing(7” long by 6”)
•same strapping setup that of niittymaki (including loops on top of each knee lift and square knee wing for the strap to run through keeping the strap in place)
•Thinnest possible profile
•NHL transfer logos
•one inner calf rap that fully wraps around calf starting from the side of the calf stabilizer to meet the pad and lock on the side of the strap buckles (like the TPS calf wrap)
•Calf wrap on inside and outside of boot area to conceal the boot strap and buckle and the boot of the skate on both sides(like lundqvist and his TPS mod(the wrap on the inside of the boot area attaches to the calf wrap on the same side no cut in between the two(inside of pad)))the outside of the pad the two wraps the calf and boot wraps aren’t connected and do not interfere with each other
•Added length on top 2 straps
•Knee lock landing gear squared up and extended but only squared up and extended to dimensions on the inside(the side of the knee lock that is part of the landing gear (7” long by 6”))
•one boot strap
•name and number embroidery
•2” longer boot strap
•No extra loops, straps or buckles unless clearly asked for in the mods featured above (picture below has a visual of strapping system and loops preferred on pads)
*any questions email before a mistake is made (not any will be made) to avoid anything either of would have to correct
Glove:
•Double Pro Palm (or w/e the pros really get)
•2” added to pocket depth
•Single T trap
•Pro Transfer Logos
•No cheater bar
•name and number embroidery
•no piping along outside of cuff
Blocker:
•Pro transfer logos
•name and number embroidery
•no piping alone outside of blocker
.
Linear Mode
